after you load the v3 firmware, a question will pop up on the Orion
screen asking if the RX366 is installed - you just say "no" (or "yes")
and off you go
Barry N1EU
On Wed, Feb 1, 2012 at 7:28 PM, Barry N1EU <barry.n1eu@gmail.com> wrote:
> absolutely - new subreceiver support was only a minor part of the new firmware
>
> Barry N1EU
>
> On Wed, Feb 1, 2012 at 7:26 PM, John Sheeley <wb4qda@yahoo.com> wrote:
>> John
>>
>> Can we use verison 3 firmware on our Orion II with out installng tne new
>> 2nd receiver ?
>>
>> 73 John wb4qda
>>
>>
>> ________________________________
>> From: John Henry <jhenry@tentec.com>
>> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
>> Sent: Wednesday, February 1, 2012 10:39 AM
>> Subject: [TenTec] 318 and 717
>>
>> I've had several emails requesting more info on the 318 and 717.
>> They are on the website, and can be found by
>> go to: www.tentec.com
>> Type in the model number into the search box on the left side of the window.
>> Hit enter
>> The link to that product will pop right up.
>> Click on the pic of that product, and then a lot of info is there.
>> Of course, if you need more info, then feel free to contact myself
>> or service at tentec.com.
>> Paul Clinton can answer questions quicker than I can.
>>
>> Already sold a bunch of 366s,
>>
>> John
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|