John -
I would like to connect a panadapter to my O2, and this is shaping up as a
better way than the current "improvisations" (buffer amps connected to SMD
components, etc.). I would like, though, to be able to switch the
below-mentioned IF output between receivers and, assuming that isn't possible,
connect the output to the main RX. Will there be a provision made for this
capability in a potential factory-installed upgrade package?
Thanks,
Mike Alexander - N8MSA
amsctalx@comcast.net
----- Original Message -----
From: "John Henry" <jhenry@tentec.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, January 30, 2012 1:16:21 PM
Subject: [TenTec] RX366, v3 firmware
Hi Pat,
The RX366 is a replacement for the existing sub-rx, giving more
features/functions/better receiver specs, making the main and sub at the
same performance level now. Along with a built in sub-rx preamp and
attenuator and slots for 3 roofing filters for the sub-rx.
Whereas it doesn't provide line level outputs for listening or computer
interfacing, it does have a 9MHz IF output connector on it in case someone
wanted to run a panadapter from their sub-receiver.
John Henry
On Mon, Jan 30, 2012 at 5:10 PM, Pat Patterson <ppattrsn at swbell.net
<http://lists.contesting.com/mailman/listinfo/tentec>> wrote:
>* Barry,*>* With the RX366 update to the OII is it possible to get
>simultaneous line level*>* output from both the Main and Sub RX? The
>connectors are there on the OII but*>* the internal audio path isn't
>complete.*>* Thanks,*>* Pat, W5VY*
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|