On my 302R, Orion and late Jupiter the knob tension is done by holding the
skirt firmly and turning the knob. It has detents.
Fernando N2FQ/6
n2fq@sbcglobal.net
On Jan 14, 2012, at 10:31 AM, d.e.warnick@comcast.net wrote:
>
>
> Barry,
>
> If you remove the knob and look at the back of it, you can easily see how the
> adjustment works. You can remove the guts and have no friction, or just set
> it higher on the shaft
>
> 73
>
> Dave
>
> WA3F
>
>
>
>
>
> ----- Original Message -----
>
>
> From: "Barry N1EU" <barry.n1eu@gmail.com>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>, "Orion565"
> <orion565@yahoogroups.com>
> Sent: Saturday, January 14, 2012 11:30:08 AM
> Subject: [TenTec] Tuning knob friction adjustment
>
> With the knob friction set as loose as it will go on my 302R remote
> pod, the friction is still too high for my liking. Does anyone know
> if the knob assembly can be opened up and the friction clutch adjusted
> to change the range of adjustment? I believe the knob assembly is the
> same design in Omni VI and Orion.
>
> Thanks & 73,
> Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|