Thanks a lot,
now i'm testing the demo of N4PY.
73 Simone IZ5DKJ
----- Original Message -----
From: "Carl Moreschi" <n4py2@earthlink.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, January 04, 2012 2:18 AM
Subject: Re: [TenTec] Orion II with transverter ?
> If you run the N4PY Orion software, the display in the N4PY software
> will read the correct operating frequency.
>
> Carl Moreschi N4PY
> 121 Little Bell Dr.
> Hays, NC 28635
> www.n4py.com
>
> On 1/3/2012 6:14 PM, Simone wrote:
>> Hi,
>> i have an O2 and i'm looking for 50Mhz transverter,
>> IF in/out Frequency 28-30MHz.
>> Can i correct the orion's diplay to read 50110.00 ?
>> Thanks
>> 73 Simone IZ5DKJ
>> http://www.qrz.com/db/IZ5DKJ
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|