TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI + Interconnect Schematic

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni VI + Interconnect Schematic
From: Clayton Brantley <clayton_n4ev@yahoo.com>
Reply-to: Clayton Brantley <clayton_n4ev@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 11 Dec 2011 13:44:56 -0800 (PST)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Wayne:  The differences between a 563 and 564 are only minor.  My 563 is a rev 
3 which makes
electrically the same as a 564.  Tentec replaced 3 boards and changed a few of 
the front panel
buttons.  The boards are the Passband Tuning board in the 563 it's 81600 and 
564 it's 81781,
the 9mhz Mixer board in a 563 is 81594 and in the 564 it's 81782, Then they 
changed the logic
board EPROMs to 564 devices.

If you print out the interconnect drawing, then make the board # changes and 
you'll be up to date.

73 Clayton N4EV



________________________________
 From: n2wk <n2wk@rochester.rr.com>
To: tentec@contesting.com 
Sent: Sunday, December 11, 2011 4:48 AM
Subject: [TenTec]  Omni VI + Interconnect Schematic
 
Thanks guys, and I hope there is not to much difference between the 563 and the 
564 interconnect.

73, Wayne N2WK
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>