There is no interconnect drawing in either the 563 or 564 manuals.
73, Barry N1EU
On Sat, Dec 10, 2011 at 5:46 PM, Clayton Brantley
<clayton_n4ev@yahoo.com> wrote:
> Wayne: I have an Omni VI rev 3 and I'm sure there is a drawing the the 563
> manual. I'll look a bit later
> today for you.
>
> I did a quick check on the 564 book that I downloaded and you're right! It's
> missing!
>
> 73 Clayton N4EV
>
>
>
> ________________________________
> From: n2wk <n2wk@rochester.rr.com>
> To: tentec@contesting.com
> Sent: Saturday, December 10, 2011 12:03 PM
> Subject: [TenTec] Omni VI + Interconnect Schematic
>
> Is there a drawing (schematic)for the Omni VI+ showing all of the
> interconnect boards available?
> I do not have one in my Omni VI Plus manual. This would be a large Drawing
> showing the entire layout of the connections from board to board. I could use
> one. Anybody Please.
>
> 73, Wayne N2WK
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|