Jim -
Thanks for the feedback, will try it tonight :)
By the way...I looked at your website and wanted to thank you for all the
information that you share with your fellow hams.
73,
Mike Alexander
amsctalx@comcast.net
----- Original Message -----
From: "Jim Brown" <k9yc@audiosystemsgroup.com>
To: tentec@contesting.com
Sent: Friday, December 9, 2011 5:32:08 PM
Subject: Re: [TenTec] Yamaha CM-500 boomset use with Orion II? ATTN K9YC
On 12/9/2011 12:32 PM, amsctalx@comcast.net wrote:
> Should I try biasing to the tip and or should I try a dropping resistor?
Stick a 4.7K resistor between V+ and the tip, connect the tip straight
to the mic input. Shield to chassis. Resistor can be very low power
rating, so it can fit inside the connector.
73, Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|