No issue at all when using the Omni VII with the Alpha 86/89/87A. We were
referring to the Omni VI/VI+.
Paul, W9AC
----- Original Message -----
From: "Richards" <jruing@ameritech.net>
To: <tentec@contesting.com>
Sent: Tuesday, December 06, 2011 3:30 PM
Subject: Re: [TenTec] Omni-VI QSK with Alpha 87A
> Golly, I had no idea there was any issue at all hooking my Omni VII to
> an Alpha amp, other than to set some sort of reasonable T/R delay. WE
> used the PTT cable/jack on the rig to the amp, and no ALC cable.
>
> Should I be reading these articles. I have a TT Centurion amp at home,
> but I sometimes use an Alpha 76 (I think) at a contest station.
>
> Should I worry?
>
> =============================== Richards -K8JHR ====================
>
> On 12/6/2011 11:34 AM, Duane Calvin wrote:
>> The same information was posted on the Alpha site at one time. Try there
>> first. Essentially, it used the TX-En keying loop of the Omni to key the
>> Alpha 87A through a diode. Vac Relay models of Alphas did not require
>> that,
>> but for some reason the PIN-diode switching amps (87A and 89, for two)
>> needed it.
>>
> =================================================================
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|