TenTec
[Top] [All Lists]

Re: [TenTec] WTB: 250hz filter for 9Mhz i.f.

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] WTB: 250hz filter for 9Mhz i.f.
From: "Rodney" <w3krq@dejazzd.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 4 Dec 2011 14:46:48 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
HE WON'T HAVE VERY LONG, -----Original Message----- 
From: Jose F Ballester 
Sent: Saturday, December 03, 2011 12:09 PM 
To: Discussion of Ten-Tec Equipment 
Subject: Re: [TenTec] WTB: 250hz filter for 9Mhz i.f. 

Natan,

You can also carry an Eagle and it's probably even smaller than a K3.

73  dePepe WP3HW







On Dec 2, 2011, at 5:54 PM, Natan Huffman wrote:

Barry,

Is this the filter used in the Orion II? I have a complete set of the type
used for the Orion II.

FYI  after using a loaded K3 at C6AAW last weekend, I replaced my Orion II
with a K3 order.

The Orion II was a good try, but the K3 has pretty much the same technology
as the Orion II AND I can carry the K3 easily on an airplane.

73

Natan W6XR, C6AXR
Freeville, NY

On Fri, Dec 2, 2011 at 3:30 PM, Barry N1EU <barry.n1eu@gmail.com> wrote:

> Looking to buy a known good 250hz 9Mhz i.f. filter - either Inrad 760
> or Ten-Tec 219 (or 221) filters.  Please email me directly.  I will
> pay cash or trade one of my filters (what do you need?).
> 
> Thanks & 73,
> Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>