Golly, I have not used my 712 adapter yet, but I was under the
impression you must remove the 4-way accessory cable, and plug in the
cable on the 712 into the Acc 1 jack on the rear panel. I have not
figured out how to make the PTT and Line-in and other 2 connectors
available if using the 712. I think yo would have to make a special
plug or adapter to use the 712 for data-audio in and out, AND also the
other features of that Acc 1 jack.
Thus, I think you use one or the other cable/adapter at any moment.
Hope this helps.
================================ James - K8JHR ================
On 11/27/2011 6:59 PM, John Molenda wrote:
> when using the TT 712 plug take the place of the supplied db9 plug which
> has the acc 1 plug on one end and the three audio plugs on the other end
> . or do I need to use both . thanks John kb2huk
> _______________________________________________
,,
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|