Just follow the schematic!
Steve G3TXQ
On 21/11/2011 12:43, Mike Hyder -N4NT- wrote:
> I believe, sir, that you are mistaken. I trust my experiences over your
> opinion. But hey, why not try to discourage the fellow from trying a very
> simple test?
>
> Mike N4NT
>
> ----- Original Message -----
> From: "Steve Hunt"<steve@karinya.net>
> To: "Discussion of Ten-Tec Equipment"<tentec@contesting.com>
> Sent: Monday, November 21, 2011 7:34 AM
> Subject: Re: [TenTec] help with Corsair II tx/rx off freq issues
>
>
>> If the problem is still present when the Offset Tuning is off, it can't
>> be the balance of those pots. With the OT switched off, the *same* pot
>> signal is used both for Tx and for Rx.
>>
>> 73,
>> Steve G3TXQ
>>
>> On 21/11/2011 04:27, Mike Hyder -N4NT- wrote:
>>> Scott, I believe there is an internal pot which balances the RIT pot on
>>> the
>>> front panel. It sounds like it is not set correctly. Hope that's your
>>> trouble for it's an easy fix.
>>>
>>> 73, Mike N4NT
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|