| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] Need a chip for an Omni 5 |
| From: | k8mp@aol.com |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 12 Nov 2011 08:52:33 -0500 (EST) |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Guys, ? I'm looking for a UDN2985A. It's used on the Xtal osc-LO mixer board in an Omni 5. I'll also consider buying?a whole board if there's one out there. ? (I just found the bad chip this morning so I haven't checked with Ten Tec yet) ? Later,? Joe _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Orion 2 query L/S on 2nd receiver answer., Dave G3RXP |
|---|---|
| Next by Date: | [TenTec] Connecting an OMNI VII to a USB port, Bill and Cindy |
| Previous by Thread: | [TenTec] FS - Omni C model 546 with 243 VFO, James Danter |
| Next by Thread: | [TenTec] Connecting an OMNI VII to a USB port, Bill and Cindy |
| Indexes: | [Date] [Thread] [Top] [All Lists] |