Before you make any electrical adjustments, you may want to check and
be sure that you have the PTO reassembled AND installed correctly with
all dials, etc mechanically aligned. Most of the time the alignment you
are referring too is to insure good tracking. I am assuming that the
calibrations was not off that much before (35 KHz). That is a big
correction to make with the inductor. I have rebuilt a Corsair II and
an Argosy 525D, but not my C21, so I don't speak from firsthand
experience on this particular radio.
73, Dave - W3NP
On 10/30/2011 2:56 PM, Kevin KJ4WLN wrote:
> Hi. I picked up a Century 21 at a hamfest and rebuilt the PTO. Now it is
> about 35khz low. Can someone point me to a current source for the alignment
> tool? Is there a standard part number I should be looking for?
>
> Are any of these what I need?
>
> http://www.mcmelectronics.com/product/22-3915&scode=GS111&CAWELAID=220255881
> http://www.hmcelectronics.com/product/GC-Electronics/18-530
>
> The trouble is I'm not sure what exactly I'm looking for because it doesn't
> seem to have a name.
>
> This was my first attempt to repair a old rig, and I have to say it was a
> lot of fun. I think I'll be looking for more Ten Tecs in the future.
> I just want to get it perfect and I'm afraid of cracking that slug. I'd
> also rather not just blindly buy alignment tools hoping to get the right
> one.
>
> Thanks!
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|