Mike,
I do not have a 566. I have a 565. As an idea, go to
https://www.tentec.com/downloads/manuals/565/Orion%20V2%20Logic%20Mod.pdf
and there are pictures of the cabling for the front panel. The 566 probably
is similar enough that you can satisfy yourself that nothing is missing.
73,
John
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Mike Gusky
Sent: Saturday, October 29, 2011 11:54 AM
To: tentec@contesting.com
Subject: [TenTec] Orion 2 Block diagram
Does anyone know where I can get a block diagram for the 566 that indicates
the interconnecting cables between boards? Just replaced my front panel and
noticed that one TMP connector (I think it was J17) on the board behind the
front panel didn't have a matching TMP plug. The panel change-out went well
and only ran into a few minor issues. Oh, almost forgot..everything worked
just fine after I put it back in service. Will be glad to share with anyone
interested in tackling this task.
Tnx
Mike
K5UX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|