Thanks a lot Floyd,
but how can you sincronize orion
frequency with SpectraVue ?
Are you using " TenTec orionII - 9mhz if "
option on extradio setup?
Hi, thanks so much.
73 Simone IZ5DKJ
----- Original Message -----
From: "Floyd Sense" <floyd@k8ac.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, October 09, 2011 1:58 PM
Subject: Re: [TenTec] Question
> No - the VFO-B frequency is not shown. If enough folks ask Moe to add
> that feature, maybe it will happen. Over time, I've decided that
> showing the VFO-B position on the trace is less important that I first
> thought. When you move the cursor into the trace window, the frequency
> indicated by the point on the cursor does display to the left below the
> window. So, you can quickly read the frequency you want to try calling
> on and manually set VFO-B via the Orion knob.
>
> I've found that while watching a trace of a pile up, it's rare to be
> able to actually pinpoint the guy that the DX station is currently
> working. Even when the DX station calls "W4XXX ONLY", you'll still see
> 6 stations answer him and that will continue till the end of the contact!
>
> 73, Floyd
>
> On 10/9/2011 7:05 AM, Simone wrote:
>> Hi Floyd,
>> can you see a orion's vfo-b position
>> on SpectraVue ?
>> This is very important for pile up split
>> operations.
>> 73 Simone IZ5DKJ
>>
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|