Send request to address above for the revised list.
Not sure what you are asking???? ( What are you saying????? )
I have built a large and growing inventory of all parts for the O6 and Paragon
1 and 2 logic boards, I found sources for all parts
and much of it was overseas, however, with name brands like Motorola, Dallas,
TI, Intel and others. I had to buy quantities above 30 each to get the prices I
purchased.
I literally spent weeks and weeks finding all of these sources and then
building storage bins just for these parts as well as a spreadsheet to keep up
with it all. ( I am beginning to wonder if it has been worth the effort)
I may offer kits to list members for my discounted cost plus 10% which is a
steal as long as it does not turn into a major hassle
The problem for most will be that the majority of IC's are soldered in place
including 40, 28, 24, 20 16, 14 and 8 pin IC's.
I also bought a large inventory of machined IC sockets, not the cheap type most
commonly used. Personally, I plan to install sockets whenever I replace a
socket unless the owner does not want this.
In my lab, I have two AIRVAC de-soldering stations which GREATLY facilitate
with the removal of IC's and not damaging the boards. I don't think the average
Ham has this kind of equipment and trying to remove all 22 IC's with solder
wick or solder sucker will be a major PITA. Not to mention,greatly increasing
the likelihood of tearing board traces and causing other board damage.
JUST CURIOUS.. Is there interest in an IC/transistor/Diode/Zener kit for the
Omni 6 Logic boards. Also remember the firmware is different between the 563
and 564. I don't have permission to duplicate Ten Tec's firmware but have not
asked. I do have the EPROMs and burner to do so.
I have not finished my calculations but I believe I could put a kit together
with all of the solid state parts and sockets for each, for under $100. And,
perhaps offer a de-soldering service to get the old hardware off the board for
$???.
Input would be appreciated
73,
Glenn WA4AOS
DSM Labs (dot Com)
-----Original Message-----
From: David Bowker <david.bowker@yahoo.com>
To: tentec <tentec@contesting.com>
Sent: Sat, Oct 1, 2011 9:46 am
Subject: [TenTec] OMNI VI/VI+ Logic Board IC Availability
I have updated my OMNI VI/VI+ logic board component availability,
source/supplier list and verified each supplier currently has inventory. The
good news is that all 22 IC's remain available from at least one source, most
from multiple sources.
Send request to address above for the revised list.
73, Dave, K1FK
Fort Kent, ME
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|