The new rx366 board is simply a replacement board for the existing
sub-receiver board. It is a very easy field replacement. It will
require the new orion version 3 firmware. There are 3 roofing filter
slots in this receiver and it does have a switchable preamp. It will be
available for both the Orion and Orion II.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 9/27/2011 8:43 AM, Barry N1EU wrote:
> Have a look/listen under "Max SubRx: Diversity& SO2V" on n1eu.com to
> learn the benefit of a good subreceiver. The original Orion
> subreceiver will get the job done in most cases, but a few of its
> faults off the top of my head that the RX366 will address:
>
> 1. tends to fold when the band is crowded with strong signals,
> especially on the low bands
> 2. when used for diversity reception, many Orion owners report issues
> with the two receivers locking to the same frequency
> 3. preamp is not switchable
>
> Also, I could be wrong, but I'd bet the RX366 will be user installable.
>
> Barry N1EU
>
> On Tue, Sep 27, 2011 at 7:35 AM, Walt Amos<waltk8cv4612amos@att.net> wrote:
>> Why would anyone want a good second receiver? All I ever use it for is
>> transmit in split mode! Maybe SO2R in contesting? You would have to send
>> your Orion 2 back to TT for the refit and it would cost you as much with
>> labor as a new Orion 3 with it built in. Not a viable solution for THIS HAM
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|