rSPD sets SSB RIT rate and CrSP sets cw RIT rate. OP set SSB rate
instead of CW rate.
73, Barry N1EU
On Sun, Sep 11, 2011 at 1:17 PM, Gert Meinen <pa3aav@hetnet.nl> wrote:
> Mike,
>
> In my Omni VI opt 3 there is in menu 3 the option CrSP this sets the rate of
> the offset tuning knob in CW mode in kHz per turn from 4.8 to .15 kHz in
> six steps.
>
> Hope this helps,
>
> 73 Gert, PA3AAV
>
>
> ----- Original Message -----
> From: "Michael Tope" <W4EF@dellroy.com>
> To: <tentec@contesting.com>
> Sent: Sunday, September 11, 2011 12:30 PM
> Subject: [TenTec] Omni 6+ RIT Tuning Rate
>
>
>> My frustration with the fast tuning rate on my Ten-Tec Omni 6+ RIT
>> function finally exceeded my "I should do something about this"
>> threshold last night during the CW Sprint contest. I just changed the
>> setting in the hidden options menu 3 (i.e. rSPD) from 4.8 KHz/turn to
>> 0.15 KHz/turn. This didn't have any effect on the tuning rate. Is there
>> a hardware and/or firmware change that is required to make this
>> particular menu parameter function properly?
>>
>> Thanks,
>>
>> Mike W4EF.......................
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|