I too have a tube of this grease and have been using it for about 20 years,
mostly for bike applications (Wayne, my tube is about half used up after
that 20 years). I believe it would be a good choice for this application.
Dave, K8AX
----- Original Message -----
From: "Wayne Dial" <w8aju_wdial@att.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, September 05, 2011 3:26 PM
Subject: Re: [TenTec] Solving PTO drift
> Charles, I use a green grease made by Phil Wood & Co. It is a bike grease
> made
> for ball and roller bearings. The 3 oz container will last you a life
> time.
> Find it @ philwood.com
>
> Wayne
>
>
>
>
>
> ________________________________
> From: Charles P. Steinmetz <charles_steinmetz@lavabit.com>
> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Sent: Mon, September 5, 2011 2:45:44 PM
> Subject: Re: [TenTec] Solving PTO drift
>
> Paul wrote:
>
>>I've been looking for a synthetic PTO grease, but everything I've tried is
>>too "sticky." What I would like is a synthetic equivalent to the
>>viscosity
>>of Lubriplate 105.
>
> Try DuPont Krytox 203. I doubt it'll ever have to be relubricated again.
>
> Best regards,
>
> Charles
>
>
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|