Jerry, what is your address for Paypal? Thanks.
Joe, W2RBA
On Fri, Sep 2, 2011 at 3:09 PM, Jerry Haigwood <jerry@w5jh.net> wrote:
> I had mentioned in a previous email that could buy and distribute the
> programmed PICs. The cost of the PIC from Mouser is about $5 each. I was
> going to charge a few $ to do the programming and shipping. I haven't set a
> price but something around $3 a PIC should do it. If you ask around, you
> may be able to get someone locally to program the part. The 16F84 part is a
> real Generic PIC. Does this sound OK?
> Jerry W5JH
>
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of Andrew Moore
> Sent: Friday, September 02, 2011 2:04 PM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Group Buy for Steve Hunt's Corsair II logic Board
>
> I understand this group buy is for just the bare board. How would be PIC
> programming be handled? I wonder if response is slowed than desired because
> people would have to find or buy a PIC programming setup to complete the
> project, even if the code is freely available.
>
> Thanks,
> --Andrew, NV1B
>
>
> On Fri, Sep 2, 2011 at 10:25 AM, Jerry Haigwood <jerry@w5jh.net> wrote:
>
>> Folks,
>>
>> The Group buy of Steve Hunt's Corsair II Logic Board is NOT going
> well.
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|