TenTec
[Top] [All Lists]

Re: [TenTec] Jupiter CW personality problem

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Jupiter CW personality problem
From: Mark Milburn <markkq0i@yahoo.com>
Reply-to: Mark Milburn <markkq0i@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 30 Aug 2011 18:14:48 -0700 (PDT)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Don't think I went far enough in explaining...if you won't be
using the CW mode, you don't HAVE to install the larger
chip.  Just download the 538 mode from the Ten Tec site and
load it into the Jupiter.  It will replace the CW mode and you 

will be able to use the Jupiter just as it was originally issued,
it just won't have the reader and probably some other stuff
that was added when they wrote the CW personality.

 
Mark Milburn    KQ0I
Des Moines, IA


on Skype as:  markkq0i


>________________________________
>From: NZ8J <nz8j@woh.rr.com>
>To: tentec@contesting.com
>Sent: Tuesday, August 30, 2011 6:05 PM
>Subject: [TenTec] Jupiter CW personality problem
>
>Hi,
>I just bought a used Jupiter, (older model with green screen and gray
>case). It looks and works fine with one problem. The guy who I bought it
>from briefly mentioned it had the CW personality Firmware. It's there
>but doesn't work like the instructions on the Ten Tec web page says.
>
>My question is, were there different levels of upgrade from the regular
>Jupiter to the newer CW personality?  I don't know much about it and the
>person I bought it from has not been of any help. The cw reader seems to
>work, I can tune a cw signal and it will decode the signal if it is
>strong enough but I can't get the radio to go back to the regular 538
>mode. 
>
>While in the CW mode, you don't have AM or FM capabilities and I like to
>listen to AM BCB/SW. I operate cw 99% of the time but have no need for
>the decode function.
>
>Holding the "MODE" switch in doesn't give me the option to pick GO 538
>or CW
>
>When turning on the radio the screen indicates :
>
>JUPITER 538 CW
>
>REV 1.03  b4  11.18.2008
>
>Any help or suggestions would be greatly appreciated. I'm reluctant to
>reload any new firmware until I have a better idea of what is going.
>
>I would like to just go back to the latest regular Jupiter firmware if
>possible. I've looked through the archives but don't really see anything
>that describes my situation.
>
>If anyone is familiar with the Jupiter and the upgrade to the cw
>personality and has an idea of what I am trying to describe I would
>appreciate corresponding off the list
>
>My email is nz8j@woh.rr.com
>
>Thanks 
>Tim
>Nz8J
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>