Verify the fuses with an ohm meter. Verify the AC ON/OFF switch. Make sure
power is really getting to the amp by using a volt meter to measure the
voltage at the AC switch. Check the transformer leads. If you have a soft
start, check that it is functioning properly. If you are unsure of
yourself, get competent help. Amps can be dangerous.
Jerry W5JH
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of John Molenda
Sent: Saturday, August 20, 2011 1:51 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] power went out
Hello all , have a ten tec titan III model 417 amplifier . keyed amp
and it shut down . no smoke or noise . the light went out on the on
/off switch and can't turn it back on . There is power to the amp and
the paper fuses look good ( how do they look when they blow ?) any Ideas
before I open her up ? thanks John
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|