My N4PY Orion software will do this operation and use either PowerSDR-IF
for the panadapter or TRX-Pan for the panadapter. You will also need
the Telespost LP-Pan device to convert the 9 mhz IF output from the
Orion to IQ signals that go your computer's sound card.
This is the procedure that has been highlited and brought to use by
Rick, VE7TK. His website describes in detail how to do all these steps.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 7/19/2011 5:51 PM, John Molenda wrote:
> In response to my question of TT providing a pan adapter in the near
> future several people responded ( thank you ) telling me how they sent
> there OII back to the factory and have them pull out the IF to a extra
> port on the back of the radio . OK , sounds good anyone remember about
> how much the mod cost ? what software and hardware do I need to make
> this pan adapter work ? I assume that the hardware extracts the IF info
> and sends it to my computer where a special software program turns it
> into a pan adapter . Is this correct ? If so any suggestions on the
> best route to take ? thanks again to you tech guys ! John molenda kb2huk
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|