Thank You Bill for your information.
Your information makes me curious to think maybe this is a problem, especially
with an older radio like the Omni D series.
I appreciate your comment and will investigate this further.
Thank You for you Input.
Regards,
Barry
KA8ENC
--- On Thu, 6/30/11, Bill Acito W1PA <w1pa@hotmail.com> wrote:
From: Bill Acito W1PA <w1pa@hotmail.com>
Subject: Re: [TenTec] Ten Tec Omni D Intermittent Receive Problem
To: TenTec@contesting.com
Date: Thursday, June 30, 2011, 7:13 AM
I had this happen on an Omni VI+, and I found a “bad pin” on a filter.
Looked as though some contaminant had been there when the pin was
soldered to the filter PCB, and it had not “wetted” well...
the pin/solder contact had “fractured”...
simply re-wetting it with a soldering iron fixed it.
Bill
W1PA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|