While it may be a bit of a pain, simply build a 20 dB attenuator and
be done with it.
Kim N5OP
At 06:36 PM 6/1/2011, you wrote:
True, but the Orion II manual says that you can adjust the output to the
transverter only from +5 to +15 dBm, and the FTV-1000 needs only -13 dBm
for full output. The Yaesu transverter may operate a bit differently
from others, as the 28 MHz drive is supplied through a separate cable
from the transceiver's transverter output jack and the PA stage of the
driving Yaesu transceiver is turned OFF in a menu item. I see that you
can turn the transmitter off in an Orion TX menu item, but I'll bet that
also disables the transverter drive output jack on the Orion.
Floyd
On 6/1/2011 7:19 PM, Carl Moreschi wrote:
> The transverter output level on the Orion is controlled by the Orion
> drive level. You can reduce the Orion drive to match what the
> transverter needs.
>
> Carl Moreschi N4PY
> 121 Little Bell Dr.
> Hays, NC 28635
> www.n4py.com
>
> On 6/1/2011 7:15 PM, Floyd Sense wrote:
>> Has anyone here used the Yaesu FTV-1000 transverter with an Orion? I
>> see the Orion II transverter output level is a bit high compared to the
>> transverter input spec. Any other concerns?
>>
>> K8AC
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|