Well, 1st off you'd have to go for the IF.... and that’s why I prefer the
N4PY sub-r mod and the FLEX-1500 running in panadapter mode using PowerSDR.
$650, ten minute (no solder mod) and away you go, without risking your
expensive radio to a soldering iron.
73 es DX,
Gary - AB9M
-----Original Message-----
From: John Molenda
Sent: Thursday, May 12, 2011 9:50 PM
To: k9yc@arrl.net ; Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] O3 wish list
On 5/12/2011 10:35 PM, Jim Brown wrote:
> On 5/12/2011 3:35 PM, CSM(r) Gary Huber wrote:
>> At $650, the FLEX-1500 is about the cheapest panadapter one can buy.
> The P3 costs $700 as a kit, which takes about an hour to build. It's a
> pre-tested board for which you screw together a simple enclosure and
> mount a few connectors. Yes, it can be easily set for a wide range of
> IF frequencies via a menu setting.
>
> 73, Jim K9YC
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
But how does it work with Ten Tec orion II ?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|