pins 1 and 2 are shorted for heaters..it is shown in the book..73 john
----- Original Message -----
From: <BUDW2GLN@aol.com>
To: <tentec@contesting.com>
Sent: Tuesday, March 29, 2011 4:34 PM
Subject: [TenTec] FT-901DM question
If anyone in this forum happens to have a FT-901DM transceiver. I have
a
question about the Accessory Plug
The manual shows the plug and where it goes (no brainer) and it is shown
in
the "Connection Diagram"
According to the manual, if the accessory socket is not used for any of
the
accessories, this plug is needed to complete the Heater Circuit for the
three output tubes (Driver & two finals) NOW, I don"t have the physical
plug..
I can build one but there is no diagram for it......I need to know how the
plug is wired :-)
Can anyone help me :-).........Is there a Yaesu forum
73
Bud, W2GLN
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.894 / Virus Database: 271.1.1/3537 - Release Date: 03/29/11
01:34:00
|