[TenTec] Serial interface between Omni VI+ and computer

[RICHARD GUIDONE <richardvalerie@rogers.com>]

Hi all:   Due to a power spike this past summer the Omni stopped talking to my 
computer logging program as well as any other Ham related software.  


I have now done the following:   re-built the Model 305 level converter,  
verified that the computer's serial port is working with loop-back tests,  sent 
the rig to  Ten Tec and asked them to check the rig out (apparently its 
okay?).     During  a telephone call with Paul at Ten Tec I was told that Ten 
Tec no longer has the ability to test my Model 305 level converter which I was 
going to send them to repair since my repair didn't appear to work.

I am now thinking about going inside the rig to replace the RS232 chip in the 
rig?

Am I missing something?   Any suggestions?

Ric - VE3XL