Charles,
>
> I thought I gathered from your description that you actually ended up
> using wires to extend the pot leads. Or maybe I misread?
I needed to extend by about 2mm, so I inserted short terminal pins into
the PCB and soldered the pot directly to them. It's as if the pot pins
were 2mm longer - not enough to do any swap over.
> Couldn't you just remember that the "out" position was at the CCW
> end, same as you'd remember that the frequencies were reversed from
> their normal relations? If the now-extraneous panel marking bugs
> you, you could cover it with tape -- or if the panel is metal with
> silkscreened graphics, some methylene chloride and a Q-Tip will take
> it right off (if the front panel has a plastic overlay, don't try this).
Yes, I could - but I was looking for a solution that kept the Corsair
front panel and functionality "untouched". It's looking like that might
be impossible!
73,
Steve G3TXQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|