TenTec
[Top] [All Lists]

[TenTec] Eagle's audio is clean!

To: tentec@contesting.com
Subject: [TenTec] Eagle's audio is clean!
From: Thomas <ac7a@cox.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 4 Feb 2011 11:07:32 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
All,

Thank you for your helpful responses. Indeed it appears that it is my 
unfamiliarity with a DSP-based radio that resulted in the  CW-note noise and 
raspiness that I described yesterday. The DSP-based radio is a different bird 
than the mostly analog radios I've used the past 42 years.

Here is what I learned about setting the Eagle audio:

1) Keep the RF gain, in the Eagle's case the IF gain, at a minimum. As the 
person responding said that prevents the ADC before the DSP from being 
overloaded. I should have know that, I work for a company that designs and 
manufactures ADCs. However, we in the trade always take it for granted that we 
usually won't be over driving the ADC input. Use the AF gain instead to control 
the volume. That is different than what I tended to do with my analog radios. 
Also, something very different about the Eagle's RF gain control is that 
setting it to minimum doesn't completely cut off the RF traveling through he 
signal chain. It has a very usable, sensible range. That had the greatest 
affect on the noise I described.

2)  Use the attenuator. I found using the attenuator nicely reduces the level 
at the front-end which of course further strengthens an already strong front 
end. That was key in the listening to the pile-ups. The Eagle has plenty of 
gain and I have always been a big fan of using an attenuator instead of the RF 
gain control. I usually ran my Omni VI+ with the attenuator on during the 
entire 160m CW contests. I found it had little affect on the super weak DX 
stations and further helped attenuate the fellow a few miles away running 
serious power.

3) Keep the noise blanker turned off. I don't have the noise blanker option, so 
that may not be applicable in this case. When I used my Omni VI+ I recall a a 
broad-band noise being generated over tens-of-kilohertz  when a strong CW 
station was operating near by. As a rule I always kept it turned off. The Eagle 
has the  DSP noise reduction which should be adequate for home use. 

There were other good tips as well and I will relate them as I learn the radio 
better. All I can really say for now is the Eagle is really cool! The 
ergonomics, size, and utility of the radio are perfectly suited for my uses. 
Wow.

'73, Thomas - AC7A

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>