Yep, Even with the LP is set to 600Hz the receiver still howls.
And, no I have not done an alignment.
Yes, the VI "should be tough to beat" especially with a full load of filters
AND the INRAD roofing filter mod too. If it were not for the howling sound with
a centered IF Shift the receiver would be acceptable.
It is noted that once I added the 400Hz INRAD 1st IF filter to my VI the AGC is
no longer getting "pumped" by adjacent QRM.
Don Jones
Arlington, WA
-----Original Message-----
From: Barry N1EU [mailto:barry.n1eu@gmail.com]
Sent: Friday, January 28, 2011 4:04 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Omni VI 1st IF Narrow CW Filter Enable?
On Fri, Jan 28, 2011 at 4:51 AM, Don Jones <ko7i@comcast.net> wrote:
> I do use the passband tuning of the OMNI VI, but I use it mainly to tone
> down the high frequency howling in the receiver audio. To be honest, it is
> awful.
>
>
Do you have "LP" engaged (you should)?
Have you ever aligned the receiver? From your description, it doesn't sound
like it's up to snuff. That receiver should be tough to beat.
73, Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|