TenTec
[Top] [All Lists]

Re: [TenTec] WARC band crystal part numbers

To: tentec@contesting.com
Subject: Re: [TenTec] WARC band crystal part numbers
From: "Dr. Gerald N. Johnson" <geraldj@weather.net>
Reply-to: geraldj@weather.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 28 Jan 2011 16:08:02 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Yes the 17 meter spur was fixed at some point. Yhe way know its fixed is 
when you have to go to the inverted side band to ge USB on 17m. Because 
the fix is to mix the 5 MHz PTO with 22 MHz to make a 27 MHz TX mixer 
injection LO rather than mixing the 5 MHz PTO with 4 to make a 9 MHz LO 
injection which has the harmonic problem. There might be a little bit 
from the SSB signal but its typically 10 or 20 dB weaker than the LO 
going into the mixer and so less of a harmonic generator. So the 17 
meter crystal will be 22 or 11 MHz instead of 4 for the old scheme.

I haven't bought from ICM lately but $25 from Tentec sounds like a 
decent buy with no questions on what the specs are.

73, Jerry, K0CQ

On 1/28/2011 2:20 PM, Bill Acito W1PA wrote:
> Thanks, Jerry.
>
> Despite reports that these were no longer available, I spoke with Paul
> at the factory, and he indeed had these (12 and 17M) for the 580 Delta ($25
> each).
>
> I nudged him about the 17m issue, and he said the Delta and the OMNI-C would
> not have this issue, only the Omni-A/B.
>
> Is that correct? (haven't had a chance to search the archive yet, but I
> remember
> something about "putting out a watt or two, even on receive")
>
> Bill W1PA
>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>