Jerry,
Iowa may be a worse environment for ice than New Jersey where I was at the
time, but I had no problems with mechanical strength. Of course, my
feedline run was only 50 feet, pretty much straight up.
73 Ray W2RS
In a message dated 1/9/2011 5:48:47 P.M. GMT Standard Time,
geraldj@weather.net writes:
But the TV grade line needs help in the support department. 22 gauge
copper wires aren't strong enough to take the wind and ice load on the
flat of the insulation. I figure on punching holes every 6 or 8 inches
and feeding an insulating rope through them, probably take a turn around
one or both sides between passes through the holes to give more support
and to break up the airfoil. I might use parachute cord for that support
rope. Then tie the upper end to the center insulator and the lower end
to some sort of anchor before going to the feedthrough to get into the
shack.
73, Jerry, K0CQ
On 1/9/2011 11:36 AM, Rsoifer@aol.com wrote:
> Tom,
>
> In a pinch, I have used Radio Shack's "heavy duty" 300-ohm twin-lead with
> power levels up to 500 watts. No problems.
>
> 73 Ray W2RS
>
>
> In a message dated 1/9/2011 5:07:40 P.M. GMT Standard Time,
> xring97015@gmail.com writes:
>
> I have been off the air for a while and am now trying to get back up to
> speed(cw only here). I need to rebuild my antenna and am curious what
you
> folks recommend for a ladder fed doublet- buy or build. Also I want to
> reassess my tuner/balun set up. I know this is a gigantic can of worms
and
> has been hashed since the beginning.
>
> I use an OMNI VI and only run 100 watts. I do not have plans to install
a
> power amplifier at this location. I am looking for efficiency and need
to
> avoid causing interference as my home is close to the neighbors.
> Thanks in advance for any suggestions.
>
> Tom Stewart N7ESE
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|