TenTec
[Top] [All Lists]

Re: [TenTec] omni 6+/ power issue

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] omni 6+/ power issue
From: mike bryce <prosolar@sssnet.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 27 Nov 2010 16:20:39 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I always like to monitor pa current, too

if the current is indicative of producing power, then phil has you in the right 
area.

if you're drawing 10 amps, and nothing coming out, it's filter problem



just an amp meter on the power supply will work


mike bryce
prosolar@sssnet.com



On Nov 27, 2010, at 4:07 PM, Phil Chambley Sr. wrote:

> The tuner confuses the issue a bit, but are the tuner settings where they 
> normally are for 20m?
> 
> Do you have a frequency counter?
> 
> Phil C. Sr.
> k4dpk
> ----- Original Message ----- 
> From: "Wayne Dial" <w8aju_wdial@att.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Saturday, November 27, 2010 4:01 PM
> Subject: Re: [TenTec] omni 6+/ power issue
> 
> 
>> Phil, I'm using a 229b tuner with a current forcing balun and open wire 
>> feeders,
>> at 20w output I can adjust the tuner  for a 1:1 swr.
>> 
>> Wayne
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>