| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] Titan 425 Initial Tune-Up settings - high VSWR |
| From: | Jim Brown <k9yc@audiosystemsgroup.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 24 Nov 2010 21:15:25 -0800 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
On 11/24/2010 8:04 PM, CSM(r) Gary Huber wrote: > I use the recommended (by TenTec) method of tuning the TITAN 425.... > alternate TUNE and LOAD for maximum power out for a given drive, > increase/decrease drive and adjust TUNE and LOAD for max power out to the > desired level. That is exactly right. And doing that will also minimize grid current, which is the main factor in tube life. 73, Jim K9YC _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| Previous by Date: | Re: [TenTec] Titan 425 Initial Tune-Up settings - high VSWR, CSM\(r\) Gary Huber |
|---|---|
| Next by Date: | Re: [TenTec] Titan 425 Initial Tune-Up settings - high VSWR, Rob Atkinson |
| Previous by Thread: | Re: [TenTec] Titan 425 Initial Tune-Up settings - high VSWR, CSM\(r\) Gary Huber |
| Next by Thread: | Re: [TenTec] Titan 425 Initial Tune-Up settings - high VSWR, kf6e |
| Indexes: | [Date] [Thread] [Top] [All Lists] |