TenTec
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [TenTec] 4229 Tuner Balun Replacement?

from [Steve Hunt] [Permanent Link][Original]
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] 4229 Tuner Balun Replacement?
From: Steve Hunt <steve@karinya.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 15 Nov 2010 14:57:39 +0000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com> 
There are some CM choke impedance measurements here:
http://www.karinya.net/g3txq/chokes/

Steve G3TXQ


On 15/11/2010 14:34, Don Jones wrote:
> I would be more interested in actual measurements than theoretical
> calculations.
>
> Don Jones KO7i
> Arlington, WA
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [TenTec] 4229 Tuner Balun Replacement?, Don Jones
Next by Date:  Re: [TenTec] 4229 Tuner Balun Replacement?, Richards
Previous by Thread:  Re: [TenTec] 4229 Tuner Balun Replacement?, Don Jones
Next by Thread:  Re: [TenTec] 4229 Tuner Balun Replacement?, Richards
Indexes:  [Date] [Thread] [Top] [All Lists]