Carl is right. It's that way on the Orion II as well.
Phil C. Sr.
k4dpk
----- Original Message -----
From: "N4PY2" <n4py2@earthlink.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, October 23, 2010 1:19 PM
Subject: Re: [TenTec] Orion I Display Question
>I think that may mean band register "c". Try pressing a band button
> multiple times and see if it changes.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Hays, NC 28635
> www.n4py.com
>
>
> ----- Original Message -----
> From: "AL7CR" <al7cr@punakea.com>
> To: "Equipment Discussion of Ten-Tec" <tentec@contesting.com>
> Sent: Saturday, October 23, 2010 1:09 PM
> Subject: [TenTec] Orion I Display Question
>
>
>>I am running version 2.063Xg software. On the A VFO display just above
>>the
>>hundred hertz value a lower case "c" is displayed. I can't find the
>>meaning of that in the manual. Can someone help me out? If it IS in the
>>manual a reference to the page and section would be helpful.
>>
>> Thanks,
>>
>> AL7CR
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|