I think that may mean band register "c". Try pressing a band button
multiple times and see if it changes.
Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "AL7CR" <al7cr@punakea.com>
To: "Equipment Discussion of Ten-Tec" <tentec@contesting.com>
Sent: Saturday, October 23, 2010 1:09 PM
Subject: [TenTec] Orion I Display Question
>I am running version 2.063Xg software. On the A VFO display just above the
>hundred hertz value a lower case "c" is displayed. I can't find the
>meaning of that in the manual. Can someone help me out? If it IS in the
>manual a reference to the page and section would be helpful.
>
> Thanks,
>
> AL7CR
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|