Thanks Rick,
Looks like I'm about a year late, oh well, now I know. Will try without the
crystal to see what happens.
BTW. Just finished a Z10000 buffer amp and installed it using your notes.
Great job. Works pretty much as expected but output at MHz seems to be down
about 10dB from an injected signal. I used the 0dB gain configuration.
Double checked to make sure it's right. Will see how it goes when the next
stage (softrock) is built and playing.
73
Martin, HS0ZED
From: Rick W [mailto:ve7tk@yahoo.ca]
Sent: 17 October 2010 00:21
To: Ten-Tec Reflector
Cc: hs0zed@csloxinfo.com
Subject: RE: [TenTec] Orion resets at every power up
Check out:
http://lists.contesting.com/archives//html/TenTec/2009-08/msg00024.html
<http://lists.contesting.com/archives/html/TenTec/2009-08/msg00024.html>
It looks like the xtal is NOT used. I know - I asked the same question?
73,
Rick
VE7TK
Website: http://www.ve7tk.com
----- Original Message -----
From: "Martin Sole" <hs0zed@csloxinfo.com>
To: "'N4PY2'" <n4py2@earthlink.net>; "'Discussion of Ten-Tec Equipment'"
<tentec@contesting.com>
Sent: Saturday, October 16, 2010 10:06 AM
Subject: RE: [TenTec] Orion resets at every power up
> There's a battery? Who'd have thought. I know it says battery failure when
> doing a RAM clear but had assumed (ha) it was just a way of saying that
> the
> process had taken place. Maybe standard device text.
>
> So where is the battery? Not on the CPU/DSP board. What is it's function?
> Which schematic is it on? Coin cell? What expected life? Hopefully
> changing
> requires no special procedure. Who knows? Questions questions??!!
>
> Thanks
> Martin, HS0ZED
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|