TenTec
[Top] [All Lists]

Re: [TenTec] looking for Argosy 525

To: "scott sheppard" <scottsheppard@videotron.ca>, "Ten-Tec Reflector" <tentec@contesting.com>
Subject: Re: [TenTec] looking for Argosy 525
From: "Mike Hyder -N4NT-" <Mike_N4NT@charter.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 25 Sep 2010 16:12:35 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Price probably wouldn't permit mine.  It is the digital model with the 
following options:

1 - 4-pole SSB filter replaced with Ten-Tec 8-pole SSB filter.
2 - 500 Hz crystal CW filter.
3 - Audio CW filter.
4 - Noise blanker.
5 - Amplifier relay board.
6 - Matching power supply model 225.
7 - Ten-Tec hand microphone.

I don't think there were other options, but if there were, I'm sure they are 
in there.  If the 30 meter band was optional, it's in there.  I also have (I 
think) spare top and bottom covers and probably a spare front panel and some 
knobs.

Mike Hyder -N4NT-

----- Original Message ----- 
From: "scott sheppard" <scottsheppard@videotron.ca>
To: "'Mike Hyder -N4NT-'" <Mike_N4NT@charter.net>
Sent: Friday, September 24, 2010 5:05 PM
Subject: RE: [TenTec] looking for Argosy 525


> Either is fine...price permitting of course
>
> 73
> scott
>
> -----Original Message-----
> From: Mike Hyder -N4NT- [mailto:Mike_N4NT@charter.net]
> Sent: Thursday, September 23, 2010 8:35 AM
> To: scottsheppard@videotron.ca
> Subject: Re: [TenTec] looking for Argosy 525
>
>
> Do you seek the analog or digital model Argosy?
>
> ----- Original Message ----- 
> From: "scott sheppard" <scottsheppard@videotron.ca>
> To: <tentec@contesting.com>
> Sent: Wednesday, September 22, 2010 8:49 PM
> Subject: [TenTec] looking for Argosy 525
>
>
>> Hello
>>
>> I am looking for an Argosy 525 if you have one for sale.
>>
>> kind regards
>> scott  VA3IED
>
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>