I wrote an article last year on a brush for cleaning SO-239 socket pins
that might be too aggressive for cleaning the power connector pins, but
maybe there can be a variation on it. Likely McMaster-Carr has a smaller
brush than the .17 caliber rifle cleaning brush I used for 1/8" banana
jacks. Its on line at: http://www.geraldj.networkiowa.com/papers/brush.pdf
The number 4754A14 or 4754A15 nylon brush from McMaster-Carr
(www.mcmaster.com)
would be more appropriate for the .093" diameter pins used for TenTec
power connectors.
Might that extra display digit actually be a shift of the decimal point
one position to the right?
73, Jerry, K0CQ
On 9/15/2010 12:18 AM, Joe Roberts wrote:
> John:
>
> No idea what to do about the extra display digit. That is a freaky
> problem, to be sure!
>
> <SNIP>
> It is also a good idea to take an afternoon to clean all of the internal
> connectors with Deoxit...and don't forget to clean the power connectors
> every now and again. I use a baby toothbrush dipped in Deoxit on the
> male pins of the board connectors, then connect/disconnect once or twice.
>
> <SNIP>
> It really doesn't "need" too many mods.
>
> Joe N5KAT
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|