I was prompted to look into the 210-X based on Al's recommendation and found
the following: http://www.eham.net/reviews/detail/670
----- Original Message -----
From: "al sirois" <alsirois@roadrunner.com>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Thursday, September 02, 2010 9:13 PM
Subject: Re: [TenTec] Don't forget guys the Atlas 210-X
> They still are around and it comes with a power supply that looks nice on
> an
> end table. The rig snaps in and out easily to bring mobile. And that I did
> when MARS used to do CW on the 1700 nets. They are all solid state and not
> very large either.
> I know where they can be serviced and parts are still available.
>
> N1mhc@arrl.net
> Al sirois
> East Boothbay, ME
>
>
> -----Original Message-----
> From: Stuart Rohre [mailto:rohre@arlut.utexas.edu]
> Sent: Thursday, September 02, 2010 6:10 PM
> To: tentec@contesting.com
> Subject: Re: [TenTec] Looking for "cheap" rig or honest and patient ham
>
> Swap meets at ham fests can bring you a good bargain. The older Ten Tec
> radios turn up there, and most Ten Tecs seem to be well taken care of.
>
> Another solution might be tube era Heathkits. The HW 101 was a classic
> and very serviceable new comers rig. The later models also turn up at
> low prices, as most hams don't care for the heavier larger radios.
>
> -Stuart Rohre
> K5KVH
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|