To: | tentec@contesting.com |
---|---|
Subject: | [TenTec] #217 swap for a #218 or #2018 |
From: | Anthony Bowyer <adb1x1@yahoo.com> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Thu, 12 Aug 2010 12:29:40 -0700 (PDT) |
List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I know this is a long shot, but I though I'd ask in case. I have a newer #217 500hz filter (has both leads of the input and output caps soldered on the PC board rather than one lead soldered to the pin) that I don't need and would like to find a #218 1.8 khz filter (preferably later vintage as well) or even the 2018 (newer replacement for the 218). Anyone up for a trade?? I tested the 217 in my Orion a few days ago and it works fine. I have a 400hz Inrad in that position and don't use the 217. Anthony, K4ZNO _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] Headphones for ORION I?, Richards |
---|---|
Next by Date: | Re: [TenTec] Headphones for ORION I?, Stuart Rohre |
Previous by Thread: | Re: [TenTec] Special note: Re: Headphones for ORION I?, Jim Brown K9YC |
Next by Thread: | Re: [TenTec] [dxlab] Re: Split operation using two radios, CSM\(r\) Gary Huber |
Indexes: | [Date] [Thread] [Top] [All Lists] |