Thanks, Gary.
As was mentioned privately, you can eliminate the need to keep your
transceiver powered up before terminating Commander by installing a ~10K ohm
resistor between CTS and +12vdc.
73,
Dave, AA6YQ
-----Original Message-----
From: Ten-Tec-Omni-VII@yahoogroups.com
[mailto:Ten-Tec-Omni-VII@yahoogroups.com]On Behalf Of CSM(r) Gary Huber
Sent: Sunday, July 25, 2010 10:00 PM
To: dxlab@yahoogroups.com
Cc: Ten-Tec-Omni-VII@yahoogroups.com; TenTec Reflector
Subject: [Ten-Tec-Omni-VII] Re: [dxlab] Commander 8.5.5 is available
Thanks Dave.
Commander 8.5.5 seems "Bullet Proof" here with my OMNI-VII. I ran the
mousewheel hard, with rapid rotations as one might do with search and
pounce, and the O7 frequency just tracked with the center indicator of the
bandspread. The CTRL Click to terminate Commander from the Launcher, is a
good way to terminate Commander before the OMNI-VII to avoid the hang (no
response from Commander) from the CTS line not being at +5VDC if the O7 is
OFF. After terminating Commander and then turning the OMNI-VII OFF, one can
continue working with DXKeeper and the other modules of DXLab or "Terminate
all enabled applications". If Commander is "unresponsive", the first thing
to check is the O7 (turn it on), if its on then insure the DB9 straight thru
cable is connected to the O7 and the same port as configured for Primary CAT
serial port.
73,
Gary - AB9M
From: aa6yq
Sent: Sunday, July 25, 2010 3:53 AM
To: dxlab@yahoogroups.com
Subject: [dxlab] Commander 8.5.5 is available
This release
- correctly initializes flow control on the primary CAT serial port (tnx to
Gary AB9M and John KI4JPL)
- provides a checkbox that can enable or disable the Secondary CAT Port (tnx
to Dana W8DH)
- updates the Configuration.htm documentation file
Commander 8.5.5 is available via the DXLab Launcher and via W8DH
<http://www.dxlabsuite.com/download.htm>
73,
Dave, AA6YQ
[Non-text portions of this message have been removed]
__._,_.___
Reply to sender | Reply to group | Reply via web post | Start a New Topic
Messages in this topic (1)
Recent Activity: a.. New Members 7
Visit Your Group
To visit your group on the web, go to:
http://groups.yahoo.com/group/Ten-Tec-Omni-VII/
MARKETPLACE
Stay on top of your group activity without leaving the page you're on - Get
the Yahoo! Toolbar now.
----------------------------------------------------------------------------
----
Get great advice about dogs and cats. Visit the Dog & Cat Answers Center.
----------------------------------------------------------------------------
----
Hobbies & Activities Zone: Find others who share your passions! Explore new
interests.
Switch to: Text-Only, Daily Digest . Unsubscribe . Terms of Use.
__,_._,___
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|