TenTec
[Top] [All Lists]

[TenTec] Omni VI Trouble Shooting Question

To: TenTec@contesting.com
Subject: [TenTec] Omni VI Trouble Shooting Question
From: Roger Rippy <svtincup@yahoo.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 20 Jun 2010 05:52:05 -0700 (PDT)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Ten Tec List
I recently purchased an Omni VI opt 3 and I am
enjoying this rig very much. I still have my Triton IV
but the Omni is now my main rig and what a rig it is!
But I have an issue that I cannot resolve. On three
different occassions I have lost all control, all LEDs
go out except the meter and I hear a steady tone from
the speaker. It does not happen with on anything like
a regular basis. These three occassions have been over 
the period of several weeks. If I turn the rig and power 
supply off, then turn it back on; everything appears to 
return to normal.

Has anyone a clue as to what is going on? I have read 
through the trouble shooting procedures and cannot find
the exact situation as to the tone and loss of leds. I have
not done a Master Reset and perhaps that is my next course
of action. Thanks for any ideas or suggestions.
73s  Rip   W7RIP    Bozeman, MT



      
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>