TenTec
[Top] [All Lists]

Re: [TenTec] Contesting & Logging for Omni VI - TNXs agn N5NA

To: <alan.n5na@gmail.com>, "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Contesting & Logging for Omni VI - TNXs agn N5NA
From: "Tom Macon" <tmacon@wi.rr.com>
Reply-to: Tom Macon <tmacon@wi.rr.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 30 May 2010 16:20:12 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
N1MM has support for the Omni VI and it works well for me.  I can't speak 
for DX4WIN.  I use N3FJP's AClog for general logging and that works fine 
with the Omni as well.

FWIW, I made the serial cable for the Omni's 25p connector to the 'puter.  I 
have a Herc II amp and its control lines are on the same 25p connector, so 
the cable is a split affair with branches that go to the Herc and to the 
computer (which still has old-fashioned serial and parallel ports).

 - Tom, K9BTQ


----- Original Message ----- 
From: "Alan Sewell N5NA" <alan.n5na@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, May 30, 2010 2:46 PM
Subject: Re: [TenTec] Contesting & Logging for Omni VI - TNXs agn N5NA


>I bought mine off of eBay.  For some reason they were about 3x more
> expensive on their website.  Only took a couple of days for it to arrive.
>
> I use N1MM for contest logging and DX4WIN for general logging.  I think
> both of those support the Omni VI.  However, if you try some software
> that doesn't have an Omni VI as a selection just try one of the older
> Icom rigs such as IC735.  The Omni VI & VI+ use the Icom command set.
>
> Alan  N5NA
>
> Roger Rippy wrote:
>> OK Alan, thanks a million my friend. This is the kind
>> of help that I was looking for. I sent an email to the
>> Kawa Mall web site asking about the adapter and an
>> extension. Do not want to buy off ebay. I will certainly
>> check the baud rate and destination. Taking a break from
>> the CQ WPX CW contest to anwer this email; now back to
>> the radio. 73s Rip  W7RIP
>> P.S. Which logging software are you using with your setup?
>>
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>