Re: [TenTec] Logging software Omni VI - TNXs N5NM

[Alan Sewell N5NA <alan.n5na@gmail.com>]

It should work on the Omni VI with no problem

Just be aware you'll probably need to go into the User Option Menu on 
the Omni VI to check/set the baud rate and address to agree with 
whatever program you're using.  Also, be sure CdE is OFF.

73,

Alan  N5NA


Roger Rippy wrote:
> Thanks Alan for the info on this connector. I will give it a try. I sse where 
> ii is claimed to work for Omni VI+; hope that will apply to Omni VI opt 1. 
> Best regards & 73s Rip W7RIP
>
>
>
>       
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>   
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec