Phil:
Thanks for the tip on the Yaesu 857. What rigs, other than Ten Tec are
good on CW?
73,
Bob WB2VUF
Phil Chambley Sr. wrote:
> The waveform corners are adjustable with R24 on the Control Board.
>
> I haven't seen one yet that I felt came close to clicking, no matter how
> tight the adjustment.
>
> The worst rigs I've heard on CW in the past few years have been Yaesu
> 847/857 type.
>
> Not sure who said the Omni VI was noted for clix, but I'd like to hear the
> background.
>
> Phil C. Sr.
> k4dpk
>
>
> ----- Original Message -----
> From: "W8KZW" <w8kzw@arrl.net>
> To: <tentec@contesting.com>
> Sent: Friday, May 14, 2010 3:20 PM
> Subject: Re: [TenTec] Omni VI cw signals
>
>
>> Never had a complaint of key clicks on my Omni VI.
>>
>> - "Just curious since I am considering buying an Omni. Thanks, Rip
>> - Roger Rippy W7RIP Bozeman, Montana"
>>
>> Go for it! It's a delight to use ... with great reports on SSB too!
>>
>> 73,
>> Jeff
>> W8KZW
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|