Why don't you just solder a new 4 pin connector on it?
73,
Steve WA9JML
On 5/10/2010 7:12 PM, Ron Notarius W3WN wrote:
> So, my "new" Omni VI+ arrives and is operating flawlessly. Only thing is,
> I'm going to need a microphone with it at some point, as I can't keep
> switching the hand mike from the Corsair II back and forth. (ok, I can, but
> I'd rather not)
>
> Notice an Electro-Voice 727SR mike advertised in the used equipment list of
> a particular radio dealer online. It's advertised as "Wired for Ten-Tec."
> I call to verify the mike is still there. it is. and that it's wired for a 4
> pin T-T mike connector. they promise it is. So I give them the CC info. and
> it arrives today.
>
> You guessed it. 1/4 inch stereo mike connector is attached. Must be for an
> older T-T rig?
>
> Figures.
>
> Anyone out there with a microphone wired for an Omni that wants to work out
> a trade? I'd rather work a trade out than go through the aggravation of a
> return, especially on a mike. (Besides, I can always change connectors, but
> I'd rather not if I don't have to.)
>
> This is a grey Electro-Voice model 727 SR Ceramic Microphone. No base
> supplied with it. Still sealed in the store's bag, and if a trade is worked
> out, I will ship it that way (Fed-Ex Ground or USPS -- not UPS!!).
>
> I will be going to Dayton, so I'm willing to meet up with someone there for
> a face-to-face trade as well. (And I am going to have a word with someone
> from the dealership there)
>
> Please reply direct to w3wn@n3sh.org . Thanks!
>
> 73, ron w3wn
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|