Thanks Art, will do. 73
Ed K7UC
----- Original Message -----
From: "Art Trampler" <atrampler@att.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, May 07, 2010 11:58 AM
Subject: Re: [TenTec] Question, Omni 6 Plus
Yes. You need to have the break-in set to semi-break in, not full, and then
the vox delay will work for that.
Art
--- On Fri, 5/7/10, Ed Malmgren <janed@burgoyne.com> wrote:
From: Ed Malmgren <janed@burgoyne.com>
Subject: [TenTec] Question, Omni 6 Plus
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Date: Friday, May 7, 2010, 12:51 PM
Does anyone know if there is any hang time adjustment on the relay keying a
non T T amp? thanks and 73
Ed K7UC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|